IO Transceiver

Category:

Wireless Input Monitoring / Relay Control via a Transceiver

The I0 Transceiver has 2 Relay Outputs, 2 Galvanically Isolated 5V tied inputs (use dry-contacts to control these inputs), 2 Galvanically isolated 4 to 20mA Analogue Outputs, 2 Analogue inputs (0 to 5 VDC OR 0 to 20mA). It also makes use of a LoRA radio to create a local area network (thus NOT LoRA WAN connected, thus no monthly fees) via a proprietary TDMA mesh protocol.

This IO Transceiver app is used to configure and view parameters of the wireless input / output transceiver of NIST Control Systems (Pty) Ltd called the IO Transceiver.

By being connected via Bluetooth to ANY node in the network:

  • All input and output states of the entire network can be viewed.
  • The RSSI of the entire network can be viewed

Additional information

Features

2 Dry Contact Inputs
2 Relay Outputs (Dry Contacts)
2 Analog Inputs
2 Analogue Outputs
IP51 Enclosure
Includes LoRa Transceiver Module with Whip Antenna
Mains or DC powered supply

Optional Features

Power Supply Input Voltage
12VDC (we can also supply a Solar Panel, Battery and Charger kit)
230VAC

IO Transceiver App

– Commission nodes into a new network (2 to 15 nodes per network)
– Replace dead nodes (thus allowing the network to recover full functionality after a node was damaged beyond repair)
– Configure Relay Output logic (based on the status of ONE or MANY inputs In the network via up to 8 standard logic operands: NOT, AND, NAND, OR, NOR, XOR and XNOR)
– Configure Analogue Outputs (link with single Analogue Input in the network with optional signal inversion)
– Uncommission a node from the network for relocation purposes).

Technical Specifications

AC INPUT: 190 to 260VAC
DC INPUT: 9 to 26 VDC
POWER CONSUMPTION: 150mA max on 5VDC secondary side
INPUTS: 2 Galvanically isolated 5V tied inputs (use dry-contacts to control these Inputs), 2 Analogue inputs (terming selectable 0 to 5 VDC OR 0 to 2OmA)
OUTPUTS: 2 Relay Outputs (240VAC, 5A contact rating with N/O, COM and N/C terminals), 2 Galvanically isolated 4 to 20mA Analogue Outputs (31VDC max loop supply voltage)
RF: 869.5 MHz, LoRa modulation, one-to-many broadcast topology using one of 18 spread-factor, bandwidth combinations per network.
REAL WORLD TESTED RANGE BETWEEN TWO NODES: 5km
INTERFACE: RS232
CONTROLLER VOLTAGE: 230/400/525VAC
FREQUENCY RANGE: 40→70 Hz
CONSUMPTION: 4VA
MAX. CONTACT CAPACITY: 60W (e.g. 230V, 250mA)
TEMP RANGE: -15→70°C
WEIGHT: ±500 g
DIMENSIONS: 85 x 130 x 50mm

Reviews

There are no reviews yet.

Be the first to review “IO Transceiver”

Your email address will not be published. Required fields are marked *